• Pinch rollers are at positions
where the material cannot be pinched. |
|
Press the ENTER
key, and lower the loading lever.
![](image/kuuhaku_f6f6f6.png)
Move the pinch rollers to the correct positions, and load
the material again.
![](image/kuuhaku_f6f6f6.png)
Reference:Loading
the Material |
|
Note: If the message appears even if the pinch rollers
are moved to the correct positions, the machine may be exposed to
direct sunlight or intense indoor lighting.
![](image/kuuhaku_w.gif)
Turn off the power, and move the machine where it is not exposed
to direct sunlight or indoor lighting.
![](image/kuuhaku_w.gif)
After moving the machine, turn on the power. |
• Attempted to ready the machine
without loading material. The material was removed when the machine
was ready to perform cutting. The material came loose while cutting. |
|
Press the ENTER
key to clear the ERROR.
![](image/kuuhaku_f6f6f6.png)
Load the material, and then make the machine ready for cutting.
![](image/kuuhaku_f6f6f6.png)
Reference:Loading
the Material |
• The amount of data stored
in the replot buffer is too large and REPLOT cannot be executed. |
|
Clear the buffer once
to reduce the data size, and execute REPLOT.
![](image/kuuhaku_f6f6f6.png)
Reference:Creating
the Same Object Repetitively |
• The machine is exposed to
direct sunlight or strong indoor lighting and was not able to detect
the origin immediately after the power was switched on. |
|
Turn off the power,
and move the machine where it is not exposed to direct sunlight
or indoor lighting. Then, turn on the power. |
• A heavy load was placed on
the motor, and the operation stopped. |
|
Turn off the power,
lower the loading lever, and load the material again.
![](image/kuuhaku_f6f6f6.png)
Reference:Loading the
Material |
![](image/maru.gif)
The
following error messages are displayed when an error occurs in the data
communication between the computer and the machine.
![](image/kuuhaku_w.gif)
To clear the error, turn off the power and then back on.
![](image/kuuhaku_w.gif)
An uninterpretable command was received.
![](image/kuuhaku_w.gif)
The number of parameters differs from the permissible number.
![](image/kuuhaku_w.gif)
The specified parameter value is outside the permissible range.
![](image/kuuhaku_w.gif)
A framing error, parity error, or overrun error occurred at the time of
data reception.
![](image/kuuhaku_w.gif)
Set the baud rate, parity, stop bit, and data bit correctly to match the
settings on your computer.
Error 16: |
BUFFER
OVERFLOW
|
![](image/kuuhaku_w.gif)
The I/O buffer overflowed.
![](image/kuuhaku_w.gif)
Use a cable appropriate for the computer. Also, set the handshaking correctly.
![](image/kuuhaku_w.gif)
Unidentified communication error occurred.