Call 3DTechnics at 1-866-202-0480 for Best Pricing!
| 
|
| JWX-30 | JWX-10 (legacy) |
INDEX
| 
| 
| 
| 
|
| Achawakorn | Bruijn | Corney | Saarikorpi | Van Tonder |
| 
| 
| 
|
| Primer | Jewelry CAM Workshop | Incomplete Rings | Power Save |
|
|
JWX-30
- Calibration Kit/Firmware v1.60: jwx-30_calibration_kit_and_firmware-v1.60.zip
- Calibration Kit/Firmware v1.50: jwx-30_calibration_kit_and_firmware-v1.50.zip
- Calibration Kit/Firmware v1.21: jwx-30_calibration_kit_and_firmware-v1.21.zip
| 
| 
| 
| 
| 
| 
|
| Jewel Studio Intro | JWX-30 Examples | Massoni Testimonial | JWX-30 Brochure | JWX-30 Features | JWX-30 Specs | JWX-30 Can Jewel |
| 
| 
| 
|
| JWX-30 Setup | JWX-30 SRP Player | JWX-30 Calibration | JWX-30 Solution |
JWX-10
- Protowizard Install: jwx-10_protowizard_installation.zip
| 
| 
| 
| 
| 
| 
| 
| 
| 
|
| Brochure 2 | Brochure 1 | AIM Award | JWX-10 Examples | JWX-10 Specs | Diamond Scribing | Lubrication | Cancel Job | Protowizard Y-Axis | Protowizard Z-Adj |
|
| Protowizard Setup |
HISTORY
The JWX-10 was introduced in 200411 as a dedicated jewelry machine. A third-party "protowizard" adapter was developed by Cutting Edge to work with the JWX-10 to allow 4-1/2 axis cutting. In 2006, protowizard support was added also to the MDX-40 model. Careful alignment of the protowizard to the JWX-10 was needed to ensure good results. Proprietary software was also required in order to run the protowizard, with a separate licensing system.
In 2008 Roland introduced the JWX-30 to address the alignment issues. The JWX-30 includes it's own fixture for 4-1/2 axis cutting which is factory-aligned. The JWX-30 includes it's own CAM package plus Rhino/Rhino Gold for designing.
It is possible to get reasonable results with both the JWX-10 and the MDX-40 with the protowizard adapter with some experience. However, 3DTechnics recommends using the JWX-30 for ring-making since the JWX-30 is easier to work with, and the JWX-10 has been end-of-lifed so there is limited support available.
